partial replacement of copper slag in fine aggregate pdf

partial replacement of copper slag in fine aggregate pdf

  • (PDF) Partial Replacement of Copper Slag as Fine Aggregate

    PDF this project present the usage of copper slag for the partial replacement for fine aggregate the experimental procedure is conducted for the... Find, read and cite all the research you ...

  • Partial Replacement Of Copper Slag In Fine Aggregate Pdf

    2017827with partial replacement of cement with silica fume and fine aggregates with copper slag. 2. EXPERIMENTAL PROGRAMME The Experimental Program was designed to investigate the effect on the mechanical properties of the concrete by using copper slag as a partial replacement for fine aggregate with different proportions vi. 10 20 30 40 and 50

  • Partial Replacement of Copper Slag as Fine Aggregate

    Partial Replacement of Copper Slag as Fine Aggregate Ambrish E1, Dhavamani Doss S2, ShanmugaNathan N3, ... concrete with partial replacement of fine aggregate by copper slag with various percentages of 0%, 10%, 15% and 20%. The specimens were casted for 7days, 14 days and 28 days then tested. The results are presented above. V. REFERENCES [1] Al-Jabri, K. and Makoto Hisada. “Copper slag

  • Utilization of Copper Slag in M-Sand as Partial ...

    This paper reports the investigation carried out on concrete with partial replacement of fine aggregate by copper slag, Concretemixes, viz. Conventional concrete mixes with varying percentages of copper slag (10, 20, 30 and 40%) as fine aggregate replacement material were investigated.

  • Copper slag as fine aggregate for high performance concrete

    The effect of copper slag addition as replacement of fine aggregate on the density of normal and high strength concretes is shown in Fig. 1. It can be seen from Fig. 1 that there is general increase in the density of both normal and high strength concretes with the increase of copper slag replacement

  • Study on Glass Fibre Reinforced Concrete with Partial ...

    Limestone fibre reinforced concrete with copper slag as a partial replacement of fine aggregate. The parameters of the study included by replacing the fine aggregate by copper slag with 60% and by varying the volume fraction of Limestone fibre 0.5%, 1% and 1.5%. The grade of concrete is M20. The specimens were cured for 7 and 28 days. The basic ...

  • Author: I. Hubert Christopher, A.Subhashini, K. Shivani Preethi, P. Shrilakshmi, N. Ranjitha
  • Experimental Investigation of Copper Slag Replacement of ...

    use Of copper slag in concrete for the partial replacement of sand and cement. Many researchers have already found it possible to use copper slag as a concrete aggregate, because copper slag has similar particle size characteristics likely to that of sand. Fine grained powder of copper slag can be used as a supplementary cementing material to

  • 5/5(2)
  • EXPERIMENTAL STUDY OF CONCRETE WITH COPPER SLAG FOR ...

    Copper slag replacement of 0%, 10%, 20%, 30%, 40%, and 50% are used. This experimental study presents the result of compressive strength test on concrete containing copper slag partially replaced by fine aggregate. The obtained results were compared with those of conventional cement concrete made with Ordinary Portland Cement.

  • A Review on Partial Substitution of Copper Slag with Sand ...

    as a partial replacement as a substitute for aggregates. Mechanical property of copper slag has good sound characteristics, good abrasion resistance and good stability for aggregate use. Here an effort has been completed to accumulate the various studies done on the replacement of copper slag in fine aggregate to judge the strength of concrete. II. LITERATURE REVIEW G. Esakki Muthu et. al ...

  • Author: Paresh Tiwari, Anil Kumar Saxena
  • Strength and durability characteristics of conventional ...

    Strength and durability characteristics of conventional concrete by partial replacement of copper slag as fine aggregate M ... 55% at 40% replacement of fine aggregate by copper slag, and up to 75% replacement, concrete gain more strength than control mix concrete strength. D.Brindha and S.Nagan[28] have studied on durability of copper slag admixed concrete they told that Utilization of ...

  • Copper slag as fine aggregate for high performance concrete

    The effect of copper slag addition as replacement of fine aggregate on the density of normal and high strength concretes is shown in Fig. 1. It can be seen from Fig. 1 that there is general increase in the density of both normal and high strength concretes with the

  • partial replacement of fine aggregate in concrete with ...

    (PDF) Partial Replacement of Copper Slag as Fine Aggregate. Various mortar and concrete mixtures were prepared with different proportions of copper slag ranging from 0% (for the control mixture) to 100% as fine aggregates replacement . Experimental Study on Concrete by Replacing Fine. After a chemical, physical, mineralogical, and environmental characterization of copper slag, it is used as a ...

  • Experimental Investigation of Copper Slag Replacement of ...

    use Of copper slag in concrete for the partial replacement of sand and cement. Many researchers have already found it possible to use copper slag as a concrete aggregate, because copper slag has similar particle size characteristics likely to that of sand. Fine grained powder of copper slag can be used as a supplementary cementing material to

  • steel slag as a partial replacement in fine aggregate

    Flexural Strengthening of Reinforced Concrete Beams using Ferrocement Laminates with Partial Replacement of Fine Aggregate by Steel Slag. Download Complete Paper - Research Publish Journals pdf. evaluate the effects of replacing fine aggregate by copper slag and steel fibre as an ... of incorporation on copper slag in concrete mix as a partial replacement of. Study on the partial replacement ...

  • EXPERIMENTAL STUDY OF CONCRETE WITH COPPER SLAG FOR ...

    Copper slag replacement of 0%, 10%, 20%, 30%, 40%, and 50% are used. This experimental study presents the result of compressive strength test on concrete containing copper slag partially replaced by fine aggregate. The obtained results were compared with those of conventional cement concrete made with Ordinary Portland Cement.

  • A Review on Partial Substitution of Copper Slag with Sand ...

    as a partial replacement as a substitute for aggregates. Mechanical property of copper slag has good sound characteristics, good abrasion resistance and good stability for aggregate use. Here an effort has been completed to accumulate the various studies done on the replacement of copper slag in fine aggregate to judge the strength of concrete. II. LITERATURE REVIEW G. Esakki Muthu et. al ...

  • Copper Slag Partially Replaces Fine Aggregate in M 25 ...

    Natural fine aggregate is completely replaced by M-sand and partially by copper slag. Compressive strength is evaluated and compared up to 28 days of ages. Specific properties of concrete materials and copper slag are also studied. The entire tests were performed as per specifications.

  • Strength and durability characteristics of conventional ...

    Strength and durability characteristics of conventional concrete by partial replacement of copper slag as fine aggregate M ... 55% at 40% replacement of fine aggregate by copper slag, and up to 75% replacement, concrete gain more strength than control mix concrete strength. D.Brindha and S.Nagan[28] have studied on durability of copper slag admixed concrete they told that Utilization of ...

  • Experimental Study on Glass Fibre Reinforced Concrete with ...

    Limestone fibre reinforced concrete beam with copper slag as a partial replacement of fine aggregate. The parameters of the study included by replacing the fine aggregate by copper slag with 50%, 60%, 70% and by varying the volume fraction of Limestone fibre from 0 to 0.1% with an increment of 0.025%. The grade of concrete is M35. The specimens were ...

  • Study of Strength Properties of Concrete by Partial ...

    “Study of Strength Properties of Concrete by Partial Replacement with Fly Ash and Copper Slag in Cement And Fine Aggregate” G Swathi1, G Dinesh 2 1 Assistant Professor, Civil Engineering Department, Aditya Engineering College, Surampalem, AP. 2Assistant Professor, Civil Engineering Department, Aditya Engineering College, Surampalem, AP. Abstract- For every ton of resCopper slag

  • partial replacement of fine aggregate in concrete with ...

    (PDF) Partial Replacement of Copper Slag as Fine Aggregate. Various mortar and concrete mixtures were prepared with different proportions of copper slag ranging from 0% (for the control mixture) to 100% as fine aggregates replacement . Experimental Study on Concrete by Replacing Fine. After a chemical, physical, mineralogical, and environmental characterization of copper slag, it is used as a ...

  • Partial replacement of copper slag with treated crumb ...

    2020-09-30  Copper slag alkali-activated slag mortar containing 5% crumb rubber as a partial replacement of CS alkali-treated for 1 h. GGBFS was first mixed with fine aggregates for two minutes utilizing a mechanical mixer, and then the alkali activator solution was poured into the mixer.

  • The Behaviour of Concrete by Partial Replacement of Fine ...

    The split tensile strength for partial replacement of fine aggregate with copper slag cement with GGBS increased in the order of 1.52%, 4.47% and 5.75% for 10%CS 5%GGBS, 20%CS 10%GGBS and 30%CS 15%GGBS partial replacements respectively and decreased by 0.8% for 40%CS 20%GGBS partial replacement with respect to control specimen. 7.

  • steel slag as a partial replacement in fine aggregate

    Flexural Strengthening of Reinforced Concrete Beams using Ferrocement Laminates with Partial Replacement of Fine Aggregate by Steel Slag. Download Complete Paper - Research Publish Journals pdf. evaluate the effects of replacing fine aggregate by copper slag and steel fibre as an ... of incorporation on copper slag in concrete mix as a partial replacement of. Study on the partial replacement ...

  • Effect of copper slag as fine aggregate replacement in ...

    2019-01-01  The objective of the present study is to utilize high volume copper slag (i.e. 100%) as a replacement to fine aggregate and partially replacing cement with Nano silica. The work is carried out in two phases. In the first phase, the fine aggregate is replaced with copper slag in different percentages of 20%, 40%, 60%, 80%, and 100%.

  • Copper Slag Partially Replaces Fine Aggregate in M 25 ...

    Natural fine aggregate is completely replaced by M-sand and partially by copper slag. Compressive strength is evaluated and compared up to 28 days of ages. Specific properties of concrete materials and copper slag are also studied. The entire tests were performed as per specifications.

  • Experimental Study on Glass Fibre Reinforced Concrete with ...

    Limestone fibre reinforced concrete beam with copper slag as a partial replacement of fine aggregate. The parameters of the study included by replacing the fine aggregate by copper slag with 50%, 60%, 70% and by varying the volume fraction of Limestone fibre from 0 to 0.1% with an increment of 0.025%. The grade of concrete is M35. The specimens were ...

  • Partial replacement of Fine aggreggate by Copper Slag and ...

    2017-01-16  11 Replacement Of Fine Aggregate By Copper Slag And Cement By Fly Ash Ammini College Of Engineering, Mankara, Palakkad 5) Dr. A. Leema rose, P. Suganya,(2015) a study on Performance of Copper Slag on Strength and Durability Properties as Partial Replacement of Fine Aggregate in Concrete, International Journal of Emerging Technology and Advanced Engineering

  • A CASE STUDY ON COPPER SLAG AS PARTIAL REPLACEMENT OF FINE

    strength properties of copper slag as a partial replacement of sand at different levels (0%, 20% and 40%). Copper slag is a by-product obtained during the matte smelting and refining of copper. In the present investigation it is proposed to study the engineering properties of Copper slag viz. Slump test, compressive strength , split tensile strength after 7, 14 and 28 days at ambient room ...

  • Study on Strength of High Performance Concrete by Partial ...

     Replacement of copper slag by 45% - 60% shows increase in strength than conventional concrete.  Fine aggregate replaced by 55% have increase in strength up to 20.15% to the conventional concrete.

  • partial replacement of fine aggregate in concrete with ...

    (PDF) Partial Replacement of Copper Slag as Fine Aggregate. Various mortar and concrete mixtures were prepared with different proportions of copper slag ranging from 0% (for the control mixture) to 100% as fine aggregates replacement . Experimental Study on Concrete by Replacing Fine. After a chemical, physical, mineralogical, and environmental characterization of copper slag, it is used as a ...

  • Partial replacement of copper slag with treated crumb ...

    2020-09-30  Copper slag alkali-activated slag mortar containing 5% crumb rubber as a partial replacement of CS alkali-treated for 1 h. GGBFS was first mixed with fine aggregates for two minutes utilizing a mechanical mixer, and then the alkali activator solution was poured into the mixer.

  • Full Or Partial Fine Aggregate Replacement In Concrete ...

    Full Or Partial Fine Aggregate Replacement In Concrete Production Pdf. The behaviour of Concrete by Partial Replacement of Fine Aggregate and Cement with Copper Slag An Experimental Study M Sridevi1 Y Mahesh2 1PG Student 2Assistant Professor 12Department of Civil Engineering 12Viswanadha Institute of Technology and Management Visakhapatnam AP India AbstractConcrete has occupied an

  • (PDF) Study on Mechanical Properties of Concreteon Partial ...

    Concrete is the most popular building material in the world. It is the most consumable material after water. Concrete is a mixer of binding material, fine aggregate, coarse aggregate and water. Generally Ordinary Portland Cement (OPC) is used as a

  • Influence of Copper Slag in Concrete as Partial ...

    Influence of Copper Slag in Concrete as Partial Replacement for Fine Aggregate N. Vinoth Kumar1 S. K. Divya2 A. Sattainathan Sharma3 1,2,3Assistant Professor 1,2,3Department of Civil Engineering 1,2,3Valliammai Engineering College, Kancheepuram, India Abstract—Concrete is the widely used construction material. In which fine aggregate is one of the important constituents. An experimental ...

  • Study on Mechanical Properties of Concreteon Partial ...

    Partial Replacement of Fine Aggregate with Copper Slag Granite Powder T. Lohitha Devi M. Lakshmi Kumar PG Student Assistant Professor Department of Civil Engineering Department of Civil Engineering DNR College of Engineering Technology, Bhimavaram, Andhrapradesh, India DNR College of Engineering Technology, Bhimavaram, Andhrapradesh, India M.K.M.V Ratnam Assistant

  • An Experimental Study on Properties of Strength of ...

    Copper scum(slag) possesses chemical and mechanical properties that qualify the material to be used in concrete as a partial replacement for hydraulic cement or as a substitute for aggregates.

  • AN EXPERIMENTAL INVESTIGATION ON CONCRETE BY PARTIAL ...

    percentage of replacement. The copper slag is used as partial replacement for fine aggregate in the range of 20%, 40% and 60% by weight of sand and its optimum level is to be found. The ceramic waste tiles is used as partial replacement for coarse aggregate ranging from 10%, 20%, 30% with optimum slag content as constant. For testing the ...

  • An Experimental Study on Strength of Concrete with partial ...

    From the study of partial replacement of copper slag and quarry dust the following results are obtained. [6] 1. The highest compressive strength was obtained 41.87 Mpa for a replacement of Fine Aggregate by 40%. 2. It is observed that the Split Tensile Strength of concrete 7 to 28 Days is higher for 15% of replacement fine aggregate by C.S and Q.D. Also split tensile strength is more than ...

  • EXPERIMENTAL STUDY O N CONCRETE (M30) BY PARTIAL ...

    By replacement of copper slag as fine aggregate we can reduce the digging of river sand which effects the hydraulic structure stability and As well as we can reduce the open land fill and environmental pollution with copper slag usage it in concrete. Graphs are drawn strength vs. replacement with C Sand results are compared with normal concrete. The strength has been increased by 46% by ...